![]() WARNING: Allow 24 hours for the glue to harden thoroughly before installing your screen.ĭIY Adjustable Window Screens adhere to your window frame on all 4 sides by a continuous strip of 20mm width self-adhesive VELCRO® Brand fastener providing a slim and discreet appearance.When doing so ensure there are no traces of glue left behind and the surface is spotless again. You will need to start again with new VELCRO® strips. WARNING: The VELCRO® fastener cannot be re-positioned if you make a mistake.The VELCRO® fastener will eventually come away from the window frame if sufficient pressure is not applied, and if this happens it cannot be reused.By applying pressure this activates the ‘Pressure Sensitive Glue’, so it is important to pay special attention to the corners as these are often missed.Apply pressure to the strip of the installed VELCRO® fastener with a teaspoon or similar utensil.Continue down one side of the window frame peeling back the strip liner as you go. ![]() Hold the VELCRO® fastener strip on the edges between your thumb and forefinger, & gently peel back the liner (without touching the glue) to about 25mm (1″) and place in position on the window frame.Lay out your boards on a flat surface per the design with the pocket holes facing up. Don’t worrywe’ll snip this off afterward). ![]() ![]() (By the way, you’ll have some zipper left over at the top. Align the bottom edge of the screen to the zipper, sewing all the way up.
0 Comments
Leave a Reply. |